Section loop slider always shows column + 1 items.

marekf8 · September 26

Currently I have configured 3 colums for the slider. The section loop only shows one additional item when clicking the right arrow. There should be 6 items total in the slider but only 4 are in the slider.

When I change the columns to 2, then when clicking the right arrow, it also shows only one additional item, now having 3 items total in the slider. And same for any amount of colums. It's always columns + 1.

Phil · September 26

Hi,

Did you set the number of posts in the main settings?

Best regards

marekf8 · September 26

Hi Phil,

It was set to 0, but makes no difference if I set it to 10 for example. Still the same issue.

Phil · September 26

Please send us the WordPress dashboard and FTP access privately through the contact form, which is on the right side at https://themeforest.net/user/muffingroup#contact and we will check what might be the reason.

Notice!

Please attach a link to this forum discussion.

Sending incorrect or incomplete data will result in a longer response time.

Therefore, please ensure that the data you send are complete and correct.

Thanks

Phil · September 27

We have located the source of this issue, but we are still working to correct it.

Also, you did not sent FTP access as I asked. Please send it and remember to attach a link to this forum discussion.

Thanks

marekf8 · October 11

I have send the SFTP details as well.

Phil · October 14

It should be correct now.

Please check it out.

Best regards

Section loop slider always shows column + 1 items.

Comments